Hi there @yasserakbbach !

I tried repeating the process and get one of the dates which you do the request for, so all good until that point.

In the Process API request you make a request on a geometry. Is there a reason why you didn’t use the bbox bounds like in the dates request?

If I change the bounds part of the payload to:

"bounds": {

            "properties": {

                "crs": "http://www.opengis.net/def/crs/OGC/1.3/CRS84"

            },

            "bbox": :34.3749669970627, -5.89915791677634, 34.3781915977676, -5.90363203995753]

        },

where I use the same bbox info as you provide in the dates request, then I get a non-null image:

This probably points in the direction that your geometry+crs combo isn’t what you expect it to be.

Cheers,

Matic

Hello @matic.lubej,

Thank you for your input, the main reason why I’m sending geometry instead of bbox is the fact that I need to render the responded image on a polygon on a mapbox (Android) as shown on the figure below:

The bbox way will return a squared image, while geometry returns exactly the same sent polygon dimensions!

Hi,

OK, I understand your motivation to use geometry. Thank you for the explanation.

I see you are using CRS84, which should be similar to WGS84, with the exception of reverse coordinates (using lon/lat instead of lat/lon).

However, it doesn’t seem to me that the geometry you are using corresponds to the bounds of the original bbox you used in the beginning. I plotted both geometries with the appropriate CRS, but the two don’t overlap in the least bit.

I suggest you first make sure that you are using a geometry which corresponds to your original bbox.

Cheers

Yeah this is what I figured out too, I’ll double check and return back to you.

Thank you for your time!

Hello again @matic.lubej,

Finally I managed to fix the issue, thanks for your help I really appreciate it.

There were two problems on my side (as you stated):

1. I was mistakenly using some sort of static geometry.


2. I’ve been using wrong order lon/lat instead of lat/lon for the bbox.

Regards.