Sentinel-1 Processing Steps?

Hi,
Correct, calibration and thermal noise reduction are applied. This is done first and at the same time. After that the geolocation processing follows, either orthorectified or non-orthorectified, depending on you settings.
Note that as of this writing speckle filtering and terrain flattening are not supported.
I hope this helps

Thank you for the response!
I have some follow up questions:

• Is some kind of resempling or coregistration involved?
• Will terrain flattening be supported in the future or why wasn’t it included yet?
• During orthorectification - what kind of DEM is used?
• Are the original orbit state vectores used or is the updated orbit file applied? Why so? Is this relevant for this processing chain anyway?

Thanks

I can respond to some of these. can probably answer to the rest.
-there is no coregistration involved
-there is averaging involved on lower scales. If you use it on natural scale, there is no resampling.
-there is no terrain flattening and there are no mid-term plans to do it
-we use MapZen’s DEM (https://registry.opendata.aws/terrain-tiles/)

We use the original orbit state vectors as they are sufficient for GRD use. Of course this only applies to orthorectified imagery; for non-orthorectified they are not needed.

Hi,
Is the sigma0 calibrated Sentinel-1 data available from sentinelhub wms service?

We currently support only gamma0.

Actually you can get sigma0, you can set this in the layer settings in your dashboard (https://apps.sentinel-hub.com/dashboard/#/configurations)

It is great! And thanks for the update! I actually saw it yesterday and wondered whether it’s implemented.

is there a page or paper documenting the pre-processing steps that are done on SentinelHub for Sentinel-1 data? This page https://www.sentinel-hub.com/develop/documentation/eo_products/Sentinel1EOproducts is not comprehensive regarding the pre-processing done.

I would like to cite that resource in papers written using SentinelHub. I would like to make a version of Figure 1 here: https://www.mdpi.com/2504-3900/18/1/11 and basically be able to say that Sentinelhub does all or some of the processing steps listed there. thanks!

There is another description here:
https://docs.sentinel-hub.com/api/latest/#/data/Sentinel-1-GRD

We do not have anything more detailed, sorry about that.

I have downloaded the sentinel-1 GRD data for my AOI using the this .
I see the pixel size of the downloaded image in QGIS is 8.913742424687676191e-05,-6.860746012812835026e-05.

Where as when we download the GRD data separately and perform following steps :

we get pixel size of 10 -10 because of range doppler terrain correction step. So, is there any way by means of which we can perform this step and get the processed result?